1300 522 725 sales@crealt.com.au

LogicOil Ferrous

The LogicOil ferrous provides repeatable and accurate determination of ferromagnetic material concentration and is amazingly easy to use.

Detect Excessive Wear 

Routine wear metal analysis of machinery lubricants provides early warning of impending faults. LogicOil Ferrous™ provides an accurate, easy-to-use solution for offline and at-line measurements of ferrous wear debris concentrations.

Resulting measurements provide the insight necessary to determine if equipment is operating normally or if additional analyses are required.

Wear debris monitoring provides exceptional sensitivity to emerging problems and can often detect problems well in advance of vibration analysis, thermography, or other indirect monitoring methods.

LogicOil Ferrous is a standalone device that analyses a small sample of oil for ferrous debris. The rapid and simple operation of LogicOil Ferrous is accompanied by its outstanding sensitivity, making the device a perfect complement to any on-side or laboratory oil analysis.

How It Works

LogicOli Ferrous provides repeatable and accurate determination of ferromagnetic material concentration down to single ppm levels. It provides a mass proportional output from any size or quantity of ferrous contaminant particles, even sub-micron particles.

A lubricant sample is placed in a standard 2 ml laboratory sample tube. A debris reading is then taken by simply dropping the plastic sample tube into the sensing chamber and reading the updated display.

Kit Contents

LogicOil Ferrous is supplied in a protective foam lined plastic case. Complete with operating instructions, 12 Vdc universal mains adapter and a calibration check tube. Ready to use with 100 empty sample tubes. Additional tubes are readily available from stock.

Key Features

  • Avoid unpredicted failures
  • Facilitate planned maintenance
  • Monitor system commissioning (“break in”)
  • Assess filter performance and integrity
  • Lightweight, robust and portable
  • Small sample volume required
  • Easy-to-use
  • Calibration independent of base fluid used

Calibration

LogicOil Ferrous response is proportional to mass of ferrous material present and calibrations are performed using test standards at the time of manufacture. Particle size does not affect the measurement (in contrast to spectrometric methods).

Readings are unaffected by properties (dielectric) of fluid base, or additive package, or water content. Readings are straightforward and are presented in mass/volume standard nits, i.e.; mg Fe per liter, or PPM.

Resources & Downloads

LogicOil Ferrous Enquiry 

For more information or to arrange a call from one of the Crea Fluid Analysis Team, please complete the contact form.  If your enquiry is urgent, please call us on 1300 552 725.

LogicOil Ferrous Enquiry

NATIONAL OFFICE

EMAIL

sales@crealt.com.au

accounts@crealt.com.au

service@crealt.com.au

GET SOCIAL

PHONE

NSW: +61 2 4320 6672

VIC: +61 3 9017 4496

QLD: +61 7 3333 2171

WA: +61 8 6465 4576

NZ: +64 212 372 731

CONTACT US